InterForce
VAERN Systems is a member of InterForce in the Region of Southern Denmark, supporting the connection between business and the Danish armed forces.
InterForce Southern Denmark
Company
Built in Odense for European airspace.
VAERN Systems is a Danish defence-technology company in Odense, registered under CVR 44839806. We develop software and integration architecture for drone defence, with a focus on operator control, existing equipment and collaboration with specialist partners.
Our network
Memberships and networks
Odense Robotics
VAERN Systems is a member of Odense Robotics through the StartUp scheme. Membership was approved on 24 September 2026.
About Odense RoboticsBuild with VAERN
Your expertise. A shared next step.
We build the software and integration layer. We are looking for the people and equipment that can bring it into a real operating environment.
Heimdall Systems
VAERN Systems and Heimdall Systems have begun a collaboration to explore how their solutions can complement each other.
Sensors & communications
Bring radar, passive RF, EO/IR, edge hardware or radio interfaces. Together we can define the relevant data connection and the criteria for assessing it.
Discuss this collaborationIntegration & command systems
Help connect existing equipment and C2 workflows. The starting point is a shared interface specification and a bounded integration test.
Discuss this collaborationAuthorised effector partners
Contribute a partner-supplied effector interface and its operating constraints — under your own authorisations and only where the law allows. We focus on operator authorisation and the integration boundary; VAERN does not manufacture effectors.
Discuss this collaborationOperators & test environments
Bring a concrete use case, operator feedback or a test environment in Denmark. Help define relevant workflows and the evidence needed to assess them.
Discuss this collaborationWe continue to seek development and validation partners; roles, scope and any commercial terms are agreed individually.
01
Start with the task
A short conversation about your equipment, use case and expectations.
02
See the software demo
A guided HAMMER demo on simulated data, followed by an interface and workflow discussion.
03
Define a bounded test
Agree what to connect, who contributes what and what a useful result would demonstrate.
Facts
C / 01Danish roots. A clear focus.
Odense
Denmark — headquarters
CVR
44839806 · registered May 2024
Software
decision support and integration
Dual-use
infrastructure and defence
Our focus spans critical infrastructure, energy facilities, maritime operations and defence.
Founder
From the cockpit, the workshop and the armed forces.
Rasmus Møller Jørgensen, 23, from Odense. Three years in the Danish armed forces — in both the Army and the Air Force — trained as a mechanic, and a glider pilot for close to a decade. That is three ways of knowing the same airspace: from the ground, from the workshop, and from the cockpit.
That combination is why VAERN looks the way it does. The time in the armed forces is about how a decision is actually made, and who carries the responsibility — which is why the operator is in the loop, not the automation. The mechanic's background is about equipment that has to work in the rain, in a field, at three in the morning — which is why the interfaces are open and the moving parts are few. And gliding is about the low airspace from the inside: reading weather, traffic and other people's intentions when you have no engine to correct with.
VAERN is founded and led by Rasmus Møller Jørgensen. We welcome dialogue with technical specialists and partners who share our focus on the operator and the task.
3 yrs
in the armed forces — Army and Air Force
~10 yrs
as a glider pilot
ODENSE
where the company is registered and built
Principles
An operator supported by AI — accountable for every decision that matters.
Dual-use
Explainable
Operator supported by AI
European supply chain as a design goal
Compliance
C / 02Ownership and ethics as an advantage.
100%
Danish-owned
100%
Run from Denmark
Operator control
Human authorisation by design
European
supply chain as a design goal
VAERN is 100% Danish-owned and run from Denmark. Human control and clear responsibility guide our work.
Our approach
Start with the operator’s task.
Understand the workflow
See assessment, simulated authorisation and the decision record in a guided HAMMER software demo.
Work with relevant equipment
Define data, interfaces and responsibilities around sensors and the existing operating environment.
Make the task concrete
Use scenarios from refineries, power plants, ships and defence to discuss requirements and evidence.